// On the Ethernet Shield, CS is pin 4. Note that even if it's not // used as the CS pin, the hardware CS pin (10 on most Arduino boards, // 53 on the Mega) must be left as an output or the SD library // functions will not work.
也就是說const int chipSelect = 53; –> For Mega2560
再來根據Sd2PinMap.h中關於Mega2560腳位的定義,
1 2 3 4 5 6 7 8 9 10 11 12
#if defined(__AVR_ATmega1280__) || defined(__AVR_ATmega2560__) // Mega
/* SD card datalogger This example shows how to log data from three analog sensors to an SD card using the SD library. The circuit: * analog sensors on analog ins 0, 1, and 2 * SD card attached to SPI bus as follows: * For UNO ** MOSI - pin 11 ** MISO - pin 12 ** CLK - pin 13 ** CS - pin 10 *For Mega2560 ** MOSI - pin 51 ** MISO - pin 50 ** CLK - pin 52 ** CS - pin 53 created 24 Nov 2010 modified 9 Apr 2012 by Tom Igoe This example code is in the public domain. */
#include<SD.h>
// On the Ethernet Shield, CS is pin 4. Note that even if it's not // used as the CS pin, the hardware CS pin (10 on most Arduino boards, // 53 on the Mega) must be left as an output or the SD library // functions will not work. constint chipSelect = 53;
voidsetup() { // Open serial communications and wait for port to open: Serial.begin(9600); while (!Serial) { ; // wait for serial port to connect. Needed for Leonardo only }
Serial.print("Initializing SD card..."); // make sure that the default chip select pin is set to // output, even if you don't use it: pinMode(53, OUTPUT); //10 for UNO, 53 for Mega2560
// see if the card is present and can be initialized: if (!SD.begin(chipSelect)) { Serial.println("Card failed, or not present"); // don't do anything more: return; } Serial.println("card initialized.");
// open the file. note that only one file can be open at a time, // so you have to close this one before opening another. if (SD.exists("datalog.txt")) { Serial.println("datalog.txt exists."); } else { Serial.println("datalog.txt doesn't exist."); }
// open a new file and immediately close it: Serial.println("Creating datalog.txt...");
voidloop() { // make a string for assembling the data to log: String dataString = "";
// read three sensors and append to the string: for (int analogPin = 0; analogPin < 3; analogPin++) { int sensor = analogRead(analogPin); dataString += String(sensor); if (analogPin < 2) { dataString += ","; } }
File dataFile = SD.open("datalog.txt", FILE_WRITE); //delay(1000); // if the file is available, write to it: if (dataFile) { dataFile.println(dataString); dataFile.close(); // print to the serial port too: Serial.println(dataString); delay(1000); } // if the file isn't open, pop up an error: else { Serial.println("error opening datalog.txt"); } }